Problems with the comunication betwen two WRT54G

Discussion in 'Cisco/Linksys Wireless Routers' started by NeoSat, Jul 5, 2004.

  1. NeoSat

    NeoSat Network Guru Member

    [Sorry for my english, I'm spanish]

    I've got problems with the comunication betwen two WRT54G

    Router---WRT54G (A)))) ((((B) WRT54G---PC

    I have conexion from the PC to the router and the WRT54G (B), but not with the (A), and if I connect the PC to the (A), I've acces to it, but not to (B).

    The (A) is configured AP and (B) is client.

    I've tested with 6 different WRT54G, and all the time its the same, they are all version 1.1, and with the firmware Satori and Samadish.

    Is there anything to do?

  2. Couledouce

    Couledouce Network Guru Member

  3. KhanHex29

    KhanHex29 Network Guru Member

    Two questions you need to ask :

    1) what operating modes are the WRT54G's set to: router or gateway?

    2) what ports are you using on the router? What is connected to the internet port and what is connected to the 4-port hub.

    This should help u

    Router---WRT54G (A)))) ((((B) WRT54G---PC

    Short answer is, Set WRT54G (A) as gateway operating mode. Connect Router to internet/WLAN port of WRT54G (A). Do NOT use internet/WLAN port on WRT54G (B). Use WRT54G (B) as a 4-port hub switch only. Connect PC to 4-port hub.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice