"Proper" method for multiple APs/routers

Discussion in 'General Discussion' started by Holo20, Jan 6, 2007.

  1. Holo20

    Holo20 LI Guru Member


    In my existing workplace I have only needed, up to this point, one wireless access device. I ordered a Linksys Access Point to do the job.

    Now we are restructuring, and I need to add at least one, maybe two more APs. At the are where I need to add one, I can still pick up the signal of the existing AP, though Windows reports it as 'Very Low'.

    I was just wondering what the appropriate method is for doing this, as I would like to make it so that users only have to enter the WEP key one time, but still be able to 'roam' to the other AP without issue. I am using 10-digit WEP, not because the data is sensitive, but just to lock the wireless down from drive-by users.

    Thanks for any advice,

  2. vladbph

    vladbph LI Guru Member

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice