QoS for VoIP

Discussion in 'Other Linksys Equipment' started by utedog, Feb 6, 2006.

  1. utedog

    utedog Network Guru Member


    I posted this question in the WAG54G forum but have not had an adequate response. Yes, I realise this is a forum for Linksys VoIP products and that is not quite what this post is about, but I thought there might be someone in here who could respond to my question since it is about using VoIP with a Linksys Router. Thanks...

    I have a WAG54Gv2 firmware 1.00.39. I have a Netgear ATA connected to it for my VoIP service which works just fine. However call quality degrades when I am using the internet at the same time so I want to enable QoS. My question is how to best go about this?... Obviously I want to give the Voice traffic the highest priority. I have notice QoS mentioned in 2 places in the firmware - QoS type under the Basic Setup tab, and the QoS tab under Applications and Gaming. Do you have to configure it in both locations?
    Does anyone have a step-by-step buide on how to do this properly? I have read that the QoS doesn't work very well on the WAG54G but was wondering whether anyone has had success with it. Any help appreciated.
  2. NateHoy

    NateHoy Network Guru Member

  3. utedog

    utedog Network Guru Member

    Cool. Thanks NateHoy shall review that as soon as I get a chance.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice