Question about IP routing using Tomato

Discussion in 'Tomato Firmware' started by ajf3, Jan 31, 2008.

  1. ajf3

    ajf3 LI Guru Member

    Hi all,

    Is it possible to configure Tomato so that there are two IP's pointing to a specific mac on the network? Kind of like a loopback to except travelling through the router NAT addresses...?
  2. mstombs

    mstombs Network Guru Member

    Its not up to Tomato, the other device must publish the IP addresses. The arp protocol is used to discover the mac addresses that correspond to the IP address.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice