Reconnect VPN tunnel through command line?

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by ITPawn, Oct 18, 2005.

  1. ITPawn

    ITPawn Network Guru Member

    Does anyone know if the RV016 has some kind of command line interface that you can use to reconnect a VPN tunnel? I have 13 VPN tunnels created between a co-located server and remote locations and at least once a week have to log on to the GUI interface to reset one or more tunnels because even though the status shows "connected", the tunnel will not pass any traiffic. I would like to do this from a script if possible. Any ideas?
  2. mhakman

    mhakman Network Guru Member

    What do you mean by "reset"?

  3. ITPawn

    ITPawn Network Guru Member

    Clarify RESET

    We are experiencing problems where the tunnel is "CONNECTED" but no traffic will pass (cannot ping the private IP at the end of the tunnel). We would like to disconnect and reconnect the tunnel.

    Hope this clarifies.


  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice