REQ: External Radius support without WEP

Discussion in 'Sveasoft Firmware' started by vipit, Aug 16, 2004.

  1. vipit

    vipit Network Guru Member

    i need help... is possible turn off wep in Wireless > Wireless Security > Radius and set external Radius server only ?? In Proxim Orinoco Ap 2000, Smatrbridges Outdoor Pro i can do that but in WRT54G when i set up RADIUS i must setup WEP too.

  2. Toxic

    Toxic Administrator Staff Member

    Try telnet then type:

    wl wep off


    wl wep

    it should then show

    wep options are:

    wep Set WEP options.
    wl wep [options]
    [on|enable|1] enable WEP
    [off|disable|0] disable WEP
    [sw|software] perform WEP in software
    [hw|hardware] perform WEP in hardware

    tkip Set TKIP options.
    wl tkip [options]
    [on|enable|1] enable TKIP
    [off|disable|0] disable TKIP
    [sw|software] perform TKIP in software
    [hw|hardware] perform TKIP in hardware

    aes Set AES options.
    wl aes [options]
    [on|enable|1] enable AES
    [off|disable|0] disable AES
    [sw|software] perform AES in software
    [hw|hardware] perform AES in hardware
  3. vipit

    vipit Network Guru Member

    i do that but in netstumbler i see that wep i still active is any way to save this value permamently and reboot router ?
  4. Toxic

    Toxic Administrator Staff Member

    once you disable try these commands.

    wl wep off

    wl wep (this should show hardware setting)

    wl wep sw

    wl wep (this should show software setting)

    see if sw is enabled if so then issue

    wl wep off
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice