Reset Button vs Clear NVRAM in Admin?

Discussion in 'HyperWRT Firmware' started by Reiper, Aug 24, 2006.

  1. Reiper

    Reiper LI Guru Member

    Probably a stupid question but after flashing with Thibor 15c is it better to do the, and I quote from the master "hold the reset button for 30 secs, pull power, DON'T let go of reset and keep power off for 10 secs, plug power in and after 30 secs let go of reset button" or can you just go into the admin page and do the Clear NVRAM and reset factory defaults?

  2. Thibor

    Thibor Super Moderator Staff Member Member

    the 2 methods are the same
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice