Rflow won't work - Please Help!!

Discussion in 'DD-WRT Firmware' started by shasty22, Mar 2, 2006.

  1. shasty22

    shasty22 Network Guru Member

    I recently flashed my WRT54G v4 to DD-WRT v23 because I wanted to use the Rflow collector. The flash was successful and I was able to configure the router for Rflow, sending the Rflow and MACupd to my wired Windows XP workstation ( When I open up the Rflow collector (v2 and v3) it does not show any information. I have entered in the network info in Rflow (192.168.1) but still nothing.

    I'm not sure what I'm missing here because I followed the simple setup instructions on the DD-WRT site.

    Any help would be really appreciated.
  2. primus1024

    primus1024 Network Guru Member

    Check your WinXP firewall.
  3. shasty22

    shasty22 Network Guru Member

    Started off allowing port 2055 and 2056 through WinXP firewall and that didn't work so I disabled the firewall and its still not collecting any information. Any other suggestions??
  4. primus1024

    primus1024 Network Guru Member

    I don't know why it doesn't work :(
    Seems like you have everything properly configured.

    Which version of DD-WRT are you using?

    I have DD-WRT v23 (12/25/05) and RFlow works perfectly.

    Good luck and if you find out what was wrong please post solution here. I'm curious.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice