Router Bricked?

Discussion in 'Tomato Firmware' started by 68jimmy, Sep 18, 2007.

  1. 68jimmy

    68jimmy LI Guru Member

    Last week I upgraded from HyperWRT to Tomato on my v1 WRT54G. I had no issues with the firmware update and it went very smooth with several reboots over the past week. Last night after I was updated a WAN up script I saved the the script and clicked on the reboot within the gui. After that nothing! All I have is the power and a red diag led... I have tried numerous attempts at applying power, holding the reset, holding the reset while applying power with no luck. Any ideas on where to go from here?

    Thanks in Advance.

  2. roadkill

    roadkill Super Moderator Staff Member Member

  3. 68jimmy

    68jimmy LI Guru Member

    Actually it was not an issue with a bad flash of firmware but perhaps an issues with something in nvram after i saved my scripts... I'll see what I can do. Thanks.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice