router spontaneously reverts to factory defaults

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by dcthedude, Jun 3, 2007.

  1. dcthedude

    dcthedude LI Guru Member

    I have 3 wrvs4400n routers with the .12 firmware that keep reverting to factory defaults usually upon rebooting for a settings change. I can't get them to consistently do this, but it's happening enough to cause major problems with the 3 sites where they are located. All 3 are less than 2 months old. I thought this was a problem with the .13 firmware, but it is still happening after downgrading to .12. Is anyone else having this issue?
  2. firegate

    firegate LI Guru Member

    try to upgrade your firmware to the latest version , if the problem still exist check your voltage source and be sure that the voltage never goes down and back up, and may you try to use king of voltage regulator to ensure that you have a fixed voltage

    let me know if this help
  3. dcthedude

    dcthedude LI Guru Member

    Firegate, thanks for the reply. My routers do this with the latest firmware as well as the previous .12 firmware. All are connected to known good APC backups. I have decided since my former post to scrap these 4400n's and go with a different model.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice