Routing from wireless to LAN in client mode

Discussion in 'Sveasoft Firmware' started by ikocis, Oct 27, 2004.

  1. ikocis

    ikocis Network Guru Member

    Hello !
    I have small problem so i asked for help.
    I have next situation :

    AP(193.198.6.x) ----wireless--- WRT54GS(client mode) ---CROSSOVER LAN CABLE--- AP500(orinoco-AP-mode_192.168.2.1)----wireless--- CLIENT's(192.168.2.x)

    On AP(193.198.6.x) i already have broadband internet connection.

    I want WRT54 to be router between 193.198.6.x and 192.198.2.x, is it possible with your firmware???

    Thanks in advance,

    With regards,
    Ivan Kocis B. Sc. (E.E.)
  2. u3gyxap

    u3gyxap Network Guru Member

    It is possible.
    Just set up the router to work in AP-Client mode in the wireless setup. Make sure you put the same SSID and the MAC address of AP(192.168.6.x). Then go to Setup --> Basic setup and put address 192.168.6.z for IP, and 192.168.6.x for gateway. For DNS - whatever DNS servers you use.
    Then on Network Setup put 192.168.2.y for IP. That is the IP you should use for gateway on your network. DNS - whatever DNS servers you use.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice