Routing problems when WAN is wireless

Discussion in 'Tomato Firmware' started by vjbalex, Apr 6, 2012.

  1. vjbalex

    vjbalex Networkin' Nut Member

    I have an E4200 using the 2.4 GHz band as a Wireless Client from time to time when main ISP is down which happens too often :(

    It seems that at least with the last couple of Toastman builds 0497 and 0497.1 RT-N Ext and now with Shibby 090 RT-N AIO, the routing table does not get created correctly.

    The following lines do not get created:
    Destination Gateway / Next Hop Subnet Mask Metric Interface * 0 eth1 (WAN)
    default 0 eth1 (WAN)

    Flashed back to Shibby 083 RT-N AIO and all is well again. I can't remember for sure how far back this Wireless Client configuration was working in Toastman builds as I have used Shibby for the past few months.

    Is it just me?

    I use a static address for WAN
    "Use WAN port for LAN" is checked. (Problem exists even if that box is unchecked)

    I can add the routing table entries manually but it would seem it should not be required.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice