Routing question

Discussion in 'Linksys Official Firmware' started by manuele, Mar 3, 2006.

  1. manuele

    manuele Network Guru Member

    Hi everyone,
    Just a simple and basic routing question.

    I have a WRT54GS V4.0 a cable connection (cisco 1700) and four public IP adress. Actually (before placing linksys router) the four server was attached to an hub and go directly on Internet and are of course directly reachable from outside.

    Now I want to use my router to slow down the speed of some server and to balance bandwidth beetwen the four server.

    Is it possible to do so with original firmware?
    Should I have to put dd-wrt firmare?

  2. t4thfavor

    t4thfavor Network Guru Member

    i think you will have to put on dd-wrt and then ask again, i think it can be done by asigning the switch ports to the same vlan segment as the wan. but i am not sure.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice