RV016 Configuration Issue (Sysem Managment/Multi-WAN setting

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by Blueberry, Apr 16, 2006.

  1. Blueberry

    Blueberry LI Guru Member

    I just upgraded the Firmware of the RV016 and am having trouble with various programs. I suspect the issues has to do with the Sysem Managment/Multi-WAN settings.

    The most common app I having trouble with is Vonage. My friend is also having trouble with a MMORG. Both apps sometimes work and sometimes dont.

    If I disconnect the Cable connectivity (WAN2), everything seems to work, but of course I lose redundancy and the point of the RV016.

    If you have any thought or if you can suggest where a LAYMAN can read about System Management/Multi-Wan settings, please advise.

    I am using a RV016
    Firmware: 2.0.10

    WAN1: Speakeasy DSL Bandwidth 600/4500 Guaranteed, Static Block
    WAN2: RoadRunner Cable 300/4000, Dynamic

    I use Vonage VOIP, I have set the PRIORITY to HIGH (Port Management tab)
    I have 2 servers that I have configured using Nat one-to-one.

    Sysem Managment/Bandwidth Management
    *WAN1 600up 4500down
    *WAN2 350up 4000down
    Bandwidth Management Type: Rate Control

    System Managment/Multi-WAN settings
    * Intelligent Balancer (selected)
  2. Toxic

    Toxic Administrator Staff Member

    port forwarding issue perhaps? is UPnP enabled?
  3. Blueberry

    Blueberry LI Guru Member

    Thanks for the try, but that is not it...

    UpnP is Not Active.

    any other thoughts ?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice