RV082 - Accessing other subnets through a Client VPN

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by bob555, Feb 1, 2007.

  1. bob555

    bob555 Guest

    Hey folks,

    I can connect but I'm having a problem here accessing additional subnets ( that are not directly connected to the LAN interface of the RV082. Accessing resources on the directly connected subnet ( works fine. The RV082 has been configured to route to the 200.0 subnet and can ping 200.x addresses, but under the Client VPN settings I don't see how I can define access to additional subnets other than the directly connected interface.

    Is it possible to access the 200.0/24 subnet though the VPN? Are there any potential workarounds to access the 200.0 network?

  2. soslink

    soslink LI Guru Member

    I am having a similar problem... I think. I just setup a VPN today, the tunnel connects, but I cannot access the shares I need. See my post in RV042 and networking forums.

    If you get any help on yours, I'd appreciate it. Thanks, soslink.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice