RV082 VPN routing problem?

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by prik, Dec 7, 2005.

  1. prik

    prik Network Guru Member

    I have a problem reaching the machines at the other end of a VPN tunnel. The tunnel is established correctly (according to the log file) but I can't ping the machines on the other end. Internet connection is working fine.

    When I look at the routing table on the RV082, I don't see a valid route to the other network (xxx.yyy.0.0). I expected to see a routing entry for xxx.yyy.0.0 to 'ipsec0', but it is not there. Hence I suspect that all trafic to xxx.yyy.0.0 is send to the internet and thus fails.

    Can I adjust the routing table manually? In the web interface I cannot select 'ipsec0', but only the physical interfaces. Or do I overlook something here?

    The RV082 is replacing a Bintec router that can not only make the connection, but is also able to reach the machine on the xxx.yyy.0.0 network.

    The RV082 is connected to a Speedtouch 510i with DHCP spoofing (i.e. the RV082 gets the external IP address).

    Any help would be appreciated.
  2. jkaris

    jkaris Network Guru Member

    Try turning off PFS and see if that works.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice