RVL200 WAN port Bandwidth counter and SNMP issue

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by lamlamz, Jun 23, 2009.

  1. lamlamz

    lamlamz Addicted to LI Member

    Hi folks,

    I have been using firmware 1.1.10 for almost 8 months now. All I can say is very stable use except I have to reboot one time.

    I noticed that the bandwidth counter will reset at certain threshold and just wanted to confirm if it does at what point? As it seems that whenever it reaches about 5GB it will reset the counter and recount.

    has anyone tried SNMP monitoring? Any recommendation on how to configure to probe the RVL200 device. I tried and it does not show the information accurately and I am just wondering if this is bug?

  2. Toxic

    Toxic Administrator Staff Member

  3. lamlamz

    lamlamz Addicted to LI Member

    Simon, Thanks!
    Looks good I will try it out.
  4. lamlamz

    lamlamz Addicted to LI Member

    Simon, I just wanted to say thank you! I have not played around much but it is so easy to setup and I am now collecting and logging data. I think i is very helpful.
    Thanks again!
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice