RVL200 with WAP54GX

Discussion in 'Other Linksys Equipment' started by tlitt, Oct 5, 2006.

  1. tlitt

    tlitt Guest

    Seem to have found a compatibility issue between these two linkys products. I configured the WAP54GX with the IP info , etc. I connected to the wap via a small switch with my laptop.Then when I was finished I plugged it into our network its cause the whole network to slow down and eventually locks up the RVL200. The WAP54GX wireless led will turn on and off and the ethernet led just keeps flashing. At first i thought I had a bad unit but then I setup a RV042 to have similar setting as our RVL200. Then I plugged the WAP54GX into it and it worked fine.

    I have the newest firmware on both the WAP and the RVL. Has anyone else run across this?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice