Scheduled scandisk job always fails...

Discussion in 'Cisco/Linksys Network Storage Devices' started by bripab007, Sep 7, 2007.

  1. bripab007

    bripab007 Network Guru Member

    It doesn't matter if it's the only active device on the network at the time or not, the scheduled scandisk job always fails

    Running the scandisk job manually, however, from the web GUI works fine, 90% of the time. The only times it doesn't run manually is when someone is currently accessing the drive at the time. Even with the drive mapped to a letter in Windows, it runs fine as long as there isn't any large amount of disk activity going on

    Does anyone else have problems with the automated, scheduled scandisk job? This is running the R73 firmware.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice