SD Card Mod - Solution to the "Hardware init error&quot

Discussion in 'Modding Forum' started by Avenger20, Aug 13, 2005.

  1. Avenger20

    Avenger20 Network Guru Member

    I tried the SD Card Mod from today on my WRT54G V2, but couldn't get it to work.

    Finally decided to do some debugging in OpenWRT with the gpio prog and quickly found the problem.

    Looks like the 'DO' and 'CLK' lines where switched on my wrt54g and did not match the original picture below :

    Anyway, now the SD Mod works perfect!
    Hope this helps a lot of people with the same problem as I had :)
  2. Anonymous

    Anonymous Guest

    Let me guess: Board Rev XH? Had the same problem :)
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice