Setting QoS for a Port Range - tofu 13c

Discussion in 'HyperWRT Firmware' started by geekjock, Feb 15, 2006.

  1. geekjock

    geekjock Network Guru Member

    Under QoS settings, is it possible to set a range of ports for an application priority?
  2. NateHoy

    NateHoy Network Guru Member

    To my knowledge, only the two ranges that are already there (1-1023 "Low Ports" and 1024-65535 "High Ports").
  3. Thibor

    Thibor Super Moderator Staff Member Member

    you can actually(i think) do port range. in the "Specific Port" box, enter the following aaaa:bbbb where aaaa is start port and bbbb is end port. i think that will work for you.
  4. bcat

    bcat Network Guru Member

    Cool, I never knew that. Holy undocumented feature Batman!
  5. geekjock

    geekjock Network Guru Member

  6. NateHoy

    NateHoy Network Guru Member

    Why not just set the MAC address or Ethernet port of your VoicePulse device to HIGHEST and call it a day?

    That's exactly what I have set up on my WRT54G V4 / Tofu 13c setup for my Vonage WRTP54G, and it works great.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice