Setting up E2000 as hub/switch?

Discussion in 'Tomato Firmware' started by fractaloctopus, Jun 13, 2018.

  1. fractaloctopus

    fractaloctopus New Member Member

    I have been trying to setup my E2000 properly as a hub/switch with not so much luck so far. I'm pretty comfortable setting up computer type stuff and figuring out things with forums and whatnot, just this networking problem is getting way too frustrating. Right now I have it working, sort of. My setup currently is Telus modem -- E2000 (Tomato Firmware 1.28.0000 MIPSR2-140 K26 Max) -- two computers and tv.

    The computers and the tv have internet access, although it is about half-speed right now (90Mbps vs the 170Mbps I get if connected directly to the modem), which I would love to correct if possible as well. My main problem right now is that I use Plex Media Server to stream content within the house. It streams fine to the tv with the current setup, the problem is that my wireless Minix box in the bedroom cannot connect directly. So I'm pretty certain it's an issue with how the E2000 is currently setup.

    The Telus modem is currently at and the E2000 is at
  2. maurer

    maurer Network Guru Member

    i previously had a e2000 as AP/switch only. i've replaced it with an ea6300v1 also configured in the same way.
    i'm posting my network config page maybe it will help you
  3. fractaloctopus

    fractaloctopus New Member Member

    Awesome. Do I use the same LAN Gateway and DNS numbers and do I leave the cables attached as they already are? Thanks.
  4. Bird333

    Bird333 Network Guru Member

    Use your modem as gateway and DNS i.e.
  5. fractaloctopus

    fractaloctopus New Member Member

    Thank you so much guys! Finally got it all working!
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice