Shoutcast server and DD-WRT

Discussion in 'DD-WRT Firmware' started by DocB, Sep 20, 2006.

  1. DocB

    DocB Network Guru Member

    I run a internet radio station. i installed dd-wrt because needed more than 10 ports opened. i goto port fowarding enter ports 8000-8001 to goto internal, which is where the shoutcast server is, then enterd port 80 -80 to where my web server is. web server works but, i Can Not get to the shoutcast server.

    in the shoutcast server log.... it says "invalid password" and whenever anybody trys to get to the shoutcast server, all that comes up in the browser is "page canot be displayed"

    can anyone help me out here?

  2. DocB

    DocB Network Guru Member


    just a side note...i even turned on dmz for that internal ip address and it Still doesnt work??????

  3. DocB

    DocB Network Guru Member


    Well.. I went to to see if/what ports were open and come to find out DD-WRT did not in fact open port 8001. Seems that you need to open EACH port seperatly in the port forwarding config page. So I made 2 entries, one for port 8000 and one for 8001 and bingo! Works fine now. I just thought by the look of the port forwarding config page that it would open ports 8000 THRU 8001. It dosnt. Hope this helps somebody else because i have NO hair left lol

  4. kop48

    kop48 Network Guru Member

    You don't HAVE to use DD-WRT to open more than 10 ports. Most other firmwares that are still based as close as possible (such as HyperWRT) to the base Linksys firmware will allow you to open more ports.
  5. faisal2w007

    faisal2w007 Network Guru Member

  6. Martijno2000

    Martijno2000 Network Guru Member

    Is the invalid password message gone? Else I may have a solution...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice