SRW2048 ACL help!

Discussion in 'General Discussion' started by kleitos, Oct 22, 2006.

  1. kleitos

    kleitos LI Guru Member

    Don't know if this is the right place for this.

    I have a SRW2048 and would like to block access to specific URL's or IP's.

    Using ACL is it possible to block internet access to an IP range (example: thru from all workstations on the network.

    If yes, how? I have tried everything I can think of including reading the documentation.

  2. kleitos

    kleitos LI Guru Member

    I may have found my answer.

    "There is an implied deny for traffic that is not permitted. A single-entry ACL with only one deny entry has the effect of denying all traffic. You must have at least one permit statement in an ACL or all traffic is blocked."

    I got this from Cisco website and assume it is probably the same for Linksys.

    I was trying to just add a deny statement. Until I get back to work and can try this again does anyone have any thoughts on what I am trying to do?

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice