Switch for Linksys E2500 Power Indicator LED

Discussion in 'Tomato Firmware' started by Scottmsu, Jun 16, 2014.

  1. Scottmsu

    Scottmsu Reformed Router Member

    I want to be use the power led to for indicating if BWlimiter is turned on or off with the WPS button.
    I essentially want to replace "led white off amber on" with the command for the power led since the Linksys E series only has 1 led on the backside.

    #toggles BWlimiter on or off with WPS button and uses a led as an indicator by karogyoker
    if [ `nvram get new_qoslimit_enable` -eq 0 ];then
    led white off amber on
    nvram set new_qoslimit_enable=1
    service qoslimit start
    led amber off white on
    led white off amber on
    nvram set new_qoslimit_enable=0
    service qoslimit stop
    led amber off white off

    the command above works in switching BWlimiter on and off with alternating WPS button presses but it does not control the power led light.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice