tc filter traffic shaping help

Discussion in 'HyperWRT Firmware' started by DrZaphod, Nov 11, 2004.

  1. DrZaphod

    DrZaphod Guest

    Hi I'm trying to run the following command:
    tc filter add dev vlan0 parent 1:0 prio 0 protocol ip handle 20 fw classid 1:20
    And I keep on getting an error. Is this something to do with the version of 'tc' used by hyperwrt.

    I've observed this behaviour in hyperwrt 1.4 and 2.0b2 with a WRT45GV2 router.

    I hope you can help!
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice