telnet script

Discussion in 'Tarifa Firmware' started by 123kid, Oct 16, 2005.

  1. 123kid

    123kid Network Guru Member


    What script would I use for "wl txant 0" and "wl antdiv 0" in rc_startup.

  2. jchuit

    jchuit Network Guru Member


    This means you like to use the right antenna only.

    At this moment you have this:
    The beacon is initialy send on the right-antenna, antenna selection is full-automatic for reception.
    This means it is not needed to make the antenna selection.

    WRT54g v1, v1.1, v2 => look from the backside and connect the right antenna
    WRT54g v2.2 v3 3.1 v4 => seen from the frontside.

    Ok and now the script (rc_startup):
    /usr/sbin/wl txant 0
    /usr/sbin/wl antdiv 0

    I didn't test this script, so I think you best test it in telnet.


    note: tested this script and the above script works.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice