The Power light started flashing!!

Discussion in 'HyperWRT Firmware' started by Dowunda, Feb 18, 2005.

  1. Dowunda

    Dowunda Network Guru Member


    It was the fourth day after getting my WRT54GS flashed with HyperWRT 2.0b4 when the power light started flashing.....

    I have not lost connectivity or anything, everything was running ok!!

    I did a factory hardware reset and everything went back to normal....

    Has this happened with any one else??

  2. Toxic

    Toxic Administrator Staff Member

    usually this means a corrupt firmware. try downloading v 2.0 from hyperwrt's site and reflash.

    i need to update my downloads but i will do that all next week.
  3. electrickery

    electrickery Network Guru Member

    Whe you access the Site_Suvery.asp page, the power light also starts
    flashing. I found that clicking "Save Settings" on any page stops the flashing
    in this case.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice