Thibor 17rc3 and WRTSL54GS (max connections)

Discussion in 'HyperWRT Firmware' started by mw1001, Apr 21, 2007.

  1. mw1001

    mw1001 Network Guru Member


    I’m using Thibor’s firmware for some time (years!) with my two WRT54GSs V2.
    Recently I purchase a WRTSL54GS and the first act was update the stock firmware with Thibor.
    At the preliminaries settings, I notice the lack of “max connections†at Conntrack Settings. What’s the actual value for max connections in this firmware? It’s possible change this settings, if needed?

    Thanks in advance.
  2. Toxic

    Toxic Administrator Staff Member

    afaik the contrack changes automatically with the amount of memory available on the SL. Thibor will no doubt confirm this.
  3. mw1001

    mw1001 Network Guru Member

    Thanks for the reply!

    I’m very happy with this router. Is really nice, and Thibor’s firmware is a great improve over stock (like always!)!
    I will make some hi connections demand test (like BT and eMule).

    But I still have a few questions:

    Is possible connect more than one USB device?
    This antenna is fixed? If so, is possible make some kind of adapter to plug a HGA7S?

    and thanks again!
  4. Toxic

    Toxic Administrator Staff Member

    afaik the Antenna is fixed. and I think you could as a USB hub and use one HDD and one printer, but I dont think it will handle more than one drive. maybe Thibor could answer than one.
  5. Thibor

    Thibor Super Moderator Staff Member Member

    i have connected multiple drives using a hub. can't state re the reliability as they were only connected a short period but they worked in concert just fine when they were connected.
  6. dutchman71

    dutchman71 LI Guru Member

    Any updates on a Vista compatibility update Thibor?
  7. Toxic

    Toxic Administrator Staff Member

    when linksys release the source code then thibor will update.
  8. plugh

    plugh Network Guru Member

    I have a non-powered four port hub with four FAT32 formatted USB HDDs connected.

    Be careful about number of shares (memory demands); I'm using one per disk with all_partitions disabled, and it works fine for serving media files...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice