Thibor for WRT54GL in Bridge mode

Discussion in 'HyperWRT Firmware' started by moses_mwc00, Jun 22, 2006.

  1. moses_mwc00

    moses_mwc00 Network Guru Member

    I've been navigating in this forum but couldn't find a way to solve my problem .
    I have a Netgear modem/router connected to my DSL line.
    I have a WRT54GL router in which I installed the Thibor firmware .
    What I would like to do is to set up my wrt54GL box to make it act as an ethernet bridge to connect some ethernet devices wirelessly to my Netgear modem/router.
    Can you please point me to a FAQ or Help page where I can find the correct settings I need to enter in my wrt54gl box ?
    some indications : the router has been successfully upgraded with the Thibor firmware. Also the PC's connected to the wrt54gl get an ip address but can't go out of the network, and can't ping or access another pc on the network .
    if someone could be kind enough to show me what settings I need to enter in the linksys box, that would be great, I'm sure i'm almost there.

    Many Thanks,
  2. swinn

    swinn Network Guru Member

    Set your Internet Connection Type to Disabled.
    Set the WRT IP to be within the same subnet as your other router.
    Disable DHCP.
    Set Wireless Mode to Wireless Ethernet Bridge.
    Set all other wireless settings to be the same as your other router.
    Disable the Firewall.
  3. moses_mwc00

    moses_mwc00 Network Guru Member

    Many thanks swinn !!!

    it's working fine now.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice