Thibor14 -- Wireless operating mode / data rate?

Discussion in 'HyperWRT Firmware' started by jws99, Feb 26, 2006.

  1. jws99

    jws99 Network Guru Member

    Is there a way to see the current operating mode (802.11b or g) and data rate from the GUI (or even command line) in Thibor14? The site survey indicates the possible rates but not the current connected rate. I am running the Thibor14 unit in WET mode.

    Similarly, is there any way to tell if Speedbooster/Afterburner mode is being used? I'm bridging to another (stock) WRT54GS from a WRT54GSv4 running Thibor14.

    BTW, I'm not sure if the radio in the WRT54GSv4 is so much better than the WET54GS5 it replaced, or if it's the firmware, but this unit with Thibor14 seems to be much more stable -- the WET54GS5 was prone to random annoying reboots when signal strength dropped.

    Thanks for a great release! I'm really impressed by this firmware!
  2. Thibor

    Thibor Super Moderator Staff Member Member

    current rate= wl rate
    speedbooster status= wl afterburner(1 is on, 0 is off)
    all in the cli.
  3. jws99

    jws99 Network Guru Member

    Thanks -- just what I was looking for! With the site survey, device list, QoS, and WET capability (especially) this firmware has everything I need -- a great improvement over the stock code.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice