Discussion in 'DD-WRT Firmware' started by the_sly_dog, Jun 17, 2006.

  1. the_sly_dog

    the_sly_dog Network Guru Member

    i was running linksys firmware then flashed to dd-wrt 23sp1 standard version. flash went 100% ok
    then i opened up dos command then telnet to router and typed erase mtd nvram and it erased the nvram ok, then i logged in to the router via the gui then clicked on restore factory settings then it rebooted and it said something about( your lease time or ip address has changed or router address and something else about doing it via a wlan) it had two options at the bottom of the screen continue or close, i did click continue and it kept saying it so i clicked close,
    so now my problem is the power light keeps on flashing the other lights seem to be up ok just wont do anything apart from power light keep on blinking

    the router is a wrt54GS version 1

    running via ntl cable modem

    any help would be very helpful indeed thank u very much

  2. Chyper

    Chyper Network Guru Member


    did you try to reset the router with the reset-button on the back of your WRT54GS ? Press and hold it for ~30 secs.
    Maybe this helps.

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice