Time On GL Router Not Available

Discussion in 'Tomato Firmware' started by fubdap, Apr 8, 2011.

  1. fubdap

    fubdap LI Guru Member

    I have two routers - GL and N16. The N16 is the main router and the GL is used as an access point. Before turning the GL to access pont I did an nvram erase. Everything is working fine except when I looked at the status overview under time, it says not available. Under Basis> Time, all the items are completed and saved. Is this normal or is there any thing I can do to enable the time?
  2. TexasFlood

    TexasFlood Network Guru Member

    Guessing maybe the router can't find the NTP server. Make sure under Basic->Network, Router IP Address (on the same subnet as the N16), Subnet Mask, Default Gateway (primary router address), and Static DNS (primary router address) are all set. Your clients are probably getting all this from primary router DHCP but the AP isn't so can't find the NTP server.
  3. fubdap

    fubdap LI Guru Member

    Thanks TexasFlood. Static DNS was the problem. I did not set it on the GL. Everything is now working fine.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice