Tomato WDS Help

Discussion in 'Tomato Firmware' started by lemmanguy, Jan 14, 2008.

  1. lemmanguy

    lemmanguy LI Guru Member

    I setup the Access point + WDS according to tomato polar faq instructions.

    Wireless Macs are correct.

    I even checked device list and I can see the wds connection on both routers (Signal and Mac are seen but no IP Address) with same firmware and both have been nvram cleaned.

    The problem is I connect to the second router, but i can't browse interent or connect to router 1 via

    ALl I can do is play around with the router 2 tomato firmware :(

    any ideas help?

    Does SSID broadcast on/off matter at all?
  2. lemmanguy

    lemmanguy LI Guru Member

    Figured it out, if you are going to do Access Point + WDS, you can't use WPA2 Conneciton, only WPA1

    Good luck to you all
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice