Trouble with viktek tomato RAF

Discussion in 'Tomato Firmware' started by blackjackel, Mar 28, 2012.

  1. blackjackel

    blackjackel LI Guru Member

    I updated from tomato 1.23 to tomato RAF 1.28 ND K.2.4.37

    I haven't cleared NVRAM yet, network is behaving normal, I Will clear it when the time comes.

    I can't seem to get vlans working or set the guest SSID, I'm running WRT54G-TM which is basically a WRT54GS v1-3.

    Is my problem because this feature is not supported on this router? Did I Get the wrong firmware version? or is it because i didn't clear nvram?

    Also, it states on his website that his firmware allows for IP_Conntrack up to 16384 IP's. however when i look in the firmware it shows 8192 as the max.... again, wrong firmware? or what?
  2. blackjackel

    blackjackel LI Guru Member

    I emailed the developer and got an answer, thought i'd post it here in case someone searches for the answer in the future.


    2:57 PM (2 hours ago)



    VLAN is not build in this version, I did only for MIPSR2 chipset, WRT54g-series is too poor to handle it and I implemented this feature for powerful routers (E3000-E4200-WNR3500L-RT-N16...)
    Same happens for Contrack limits, 16.384 simultaneous connection needs 32KB nvram and around 53MB Ram, as you know WRT54G-TM have 32MB RAM only, then the firmware identifies the RAM limitation and automatically adjust Conntrack simoultaneous connection according to available RAM. You can try expanding 8192 to 16384..... but personally I think a 'normal' dsl or cable connection (6-30Mbps) is not capable to handle more than 8192 contrack because the upload channel (you need to ACK the DSLAM) limits it...

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice