Trying to configure a Zoom X3 ethernet modem with a WRT54GL

Discussion in 'Cisco/Linksys Wireless Routers' started by losimagic, Apr 18, 2007.

  1. losimagic

    losimagic LI Guru Member

    Firstly, my apologies if this is in the wrong forum, I ummed and arred over the right place and in the end decided to go here, please move if it's wrong.

    Just picked up a Zoom X3 as a replacement to a Safecom 4112 that died on me and I'm having some difficulties.

    I have the WRT setup to get the internet IP via DHCP from the modem.

    I'm having issues with getting the modem to give the IP to the WRT and hand over routing duties.

    In short, I've enabled half-bridge mode (which is about all I had to do on the Safecom) but that's not working. All that's happening is the WRT is getting an internet IP of, not 83.67.x.x

    What other settings do I need to enable/change?

    Hopefully someone else here has the same setup :)

    Many thanks for any suggestions and help :)

    edit: putting it into half-bridge mode seems to make the WRT stop seeing it - I can no longer access/ping the modem
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice