UPNP client in Tomato 1.06?

Discussion in 'Tomato Firmware' started by neutralman, Apr 7, 2007.

  1. neutralman

    neutralman Network Guru Member


    here is my problem

    I have setup like this

    Internet < - > Siemens Gigaset SE515 < - wlan - > WAP54G < - utp - > wan port WRT54G -> my Lan

    how can I open ports over UPNP on Siemens from my LAN?

    I would need some UPNP client for linux/busybox on WRT54G,
    or some kind of UPNP forwarder, so WRT54G can forward/open desired ports over UPNP on Siemens router for me
  2. GeeTek

    GeeTek Guest

    Do you really need to be re-routing with the WRT ?
  3. neutralman

    neutralman Network Guru Member

    unfortunately yes :(
  4. GeeTek

    GeeTek Guest

    As far as I can tell, you are stuck on that one. If it is just routing that you need and not necissarily the firewall that nat provides, you might get it to work if you turn off Upnp in the WRT and DMZ the station in question. Otherwize you will need one of the linux nerds in here to fix you up some wild ass scripts. If the DMZ trick works and you are concerned about wireless clients getting into your LAN, the D-Link DWL-2100 AP can isolate wireless from wired clients.
  5. GeeTek

    GeeTek Guest

    Better yet, in the Seimens, put the WAN ip of the WRT in it's DMZ. Then do normal upnp to the WRT. Problem solved. No security risk. You do not need double nat for security purposes. You do not need both routers to run the same upnp. The NAT firewall in the WRT is all anybody should need.
  6. neutralman

    neutralman Network Guru Member

    the problem is I can't login to Siemens since it is locked by ISP!

    so I can't setup WAN IP of WRT in Siemens DMZ

    it would be piece of cake if I could do that :(
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice