v1.22 client bridge mode (Wireless Ethernet Bridge) broken

Discussion in 'Tomato Firmware' started by SirDracula, Nov 26, 2008.

  1. SirDracula

    SirDracula Network Guru Member

    v1.22 breaks client bridge mode (Wireless Ethernet Bridge): you cannot access more than one computer behind the client bridge router at the same time.

    v1.21 had no such issues.
  2. Kiwi8

    Kiwi8 LI Guru Member

    Just try to make a thorough reset of your NVRAM and power off/on any of your routers/computers and see if the same problem occurs or not.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice