VLAN confusion on v23 sp2 and 54g V3

Discussion in 'DD-WRT Firmware' started by jdcynical, Dec 9, 2006.

  1. jdcynical

    jdcynical Guest

    I'm stumped. I've read and googled and keep finding reports that my V3 can do this, but I can't seem to get it to work.

    What I am trying to do is:

    Create a new vlan (ie vlan2)
    Add port 2 on the switch and the wlan interface (eth1) to VLAN2

    Why do I want to do this? Ability to monitor all the data on the LAN. In theory, I want this to happen:

    -Packets come in via the AP side of the Linksys

    -The Linksys sends the data to port 2 on the Linksys switch

    -The switch then sends the data to my core switch (which has port mirroring turned on, and sends a copy of the data to the monitoring machine)

    -The switch then sends the data back to the router side of the Linksys and does it's NAT and QoS magic

    Here is what I have done so far:

    (committed to nvram)
    nvram set vlan2hwname=et0
    nvram set vlan2ports=2
    nvram set vlan0ports="1 3 4 5*"

    (not commited yet)
    brctl addbr br1
    brctl addif br1 vlan2
    ifconfig vlan2 up
    ifconfig br1 up
    ifconfig br1

    The problem is that once I send:

    brctl delif br0 eth1
    brctl addif br1 eth1

    ...traffic on the wireless side stops flowing.

    So, oh great, wise, and more learned than I peoples, what am I missing and/or doing wrong?
  2. jdcynical

    jdcynical Guest

    Wow, almost a week and no one has anything to add?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice