vlan tagging on E2500?

Discussion in 'Tomato Firmware' started by VirtualNobody, Dec 13, 2013.

  1. VirtualNobody

    VirtualNobody Reformed Router Member


    I'm running an E2500 with Tomato 1.28 Shibby.

    I'm trying to create a guest SSID tied to VLAN 15. The E2500 is connected to my Internet router via a single cable. The internet router has the default VLAN and a tagged VLAN15 configured on it.

    I've been trying for a couple nights to get this working, but no-go.

    Is VLAN tagging even possible on this router or am I doing something wrong?

    I went to Advanced-LAN and created a BR0-BR1 bridge. No IP addresses.

    Then to the Basic -> Network tab and added an IP address to br1

    Then I created a wl0.1 WLAN interface and tied it to br1.

    Then I went to the VLAN tab and tagged VLAN 1 and 15 on port 1.

    But I can't ping the IP address I added to the bridge, and wireless clients connected to that SSID don't have any connectivity.

    Am I doing something wrong or am I asking too much from this router?
  2. VirtualNobody

    VirtualNobody Reformed Router Member

    Just a follow up, I did get this working...using the above configuration.

    Problem was, my switch was in "smart mode" so it was stripping off the tags. As soon as I tagged the port, it started working.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice