VoIP Network setup

Discussion in 'Other Linksys Equipment' started by Senan, Jun 20, 2007.

  1. Senan

    Senan LI Guru Member

    Hi Guys

    Im setting up a new small business network and Linksys VoIP system using all Linksys products. My set up is as follows I have wired and wireless broadband so im going to use the RV082 to seperate computer data on the wired wan connection and the Voice data on the wireless wan port the wireless isp is providing QoS on this connection plus they are providing us with our sip account so i have to route the voice traffic through the wireless isp.

    The switch im using is the SRW2024P so that phones have PoE power and my wireless AP has power WAP4400N.

    The phone system is Linksys SPA9000 + SPA400 + (8) SPA942 phones

    How do I set up this equipment so that computer data goes out via the wired connection and voice goes out via the wireless connection but i would like the wireless connection to load balance and provide fault tollerence.

    Can I use a VLan setup on the SRW2024P switch to seperate data and voice or will i just enable QoS on all Linksys equipment? which is best. also how do i route all voice traffic through the wireless wan port on the RV082?

    Senan :thumbup:
  2. xfag

    xfag Network Guru Member

    I would try configuring 2 vlans one vor voice and the other for data
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice