VPN Connect with SSH Sentinel and RV042

Discussion in 'Networking Issues' started by wookiee, Oct 24, 2005.

  1. wookiee

    wookiee Network Guru Member


    I have two new RV042 routers for our offices. We have successfully connected a vpn gateway to gateway. We have also successfully connected through the linksys vpn client.

    However, I would like to get SSH Sentinel to work also. I have firmware on the router and Sentinel 1.4 (build 190). I need to make a connection to my office (static ip) from my home (dynamic ip). I have spent many hours reading forums on how to set this up and I think I am missing just once piece of the puzzle.

    All examples I find are for different model routers or for two static ip addresses. I would eventually like to use ssh on the road so a two static ip scheme will not work.

    When I run a diagnostic in ssh sentinel I pass IKE phase 1 but fail in phase 2. I have tried many different things but no success.

    For remote client setup I use Dynamic IP address + Email Addr. The router log shows:

    Cannot respond to IPsec SA request because no connection is known for 10.x.xx.x/24===xxx.xxx.xx.xxx...xx.xx.xx.xx[username@email.com]===xxx.xxx.x.xxx/32

    If anybody can give me a pointer I would greatly appreciate it.

  2. wookiee

    wookiee Network Guru Member

    figured it out

    I have SSH Sentinel connecting to my RV042. I had to set up a group VPN instead of a Tunnel. I actually got the idea from reading the manual of The Greenbow VPN client software.

    Can anybody tell me what the difference is between a VPN Tunnel and and Group VPN?

    Also, client-gateway connections have to work in "Aggressive Mode". I read in a post that Aggressive Mode is not as secure and Normal Mode. Is this true? Can somebody explain this? I'm Just curious.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice