VPN connection help

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by smur1701, Dec 29, 2007.

  1. smur1701

    smur1701 LI Guru Member

    I have the RV042 router on one end and using Quick VPN client on the other.

    I setup a tunnel and I seem to be able to connect.
    Shows connected on client and looking at router summary it shows user logged in.

    However, I cannot see anything past the RV042.
    I can pick that IP, but nothing else on it's sub.
    Also sleected the Netbios checkbox on the router, but cannot see any PC or server.
    New to setting up a VPN.

    Any advice to help get past this issue and have it working 100% is greatly appreciated.

    Unsure if I have to do anything else on the RV042 or on the router on my end.

  2. DocLarge

    DocLarge Super Moderator Staff Member Member

    Unfortunately, quickvpn (by design) does not send any netbios traffic. In short, you won't see anything in "network places" regarding your other machines.

  3. smur1701

    smur1701 LI Guru Member


    Well, that stinks.
    Kind of stupid in my opinion, since they include a checkmark under the router options and package it with the quickvpn client.

    If I could at least see the other IPs that would work.

    But so far only able to get connected to the router itself. But I cannot ping anything else behind it on the same subnet. Pinging the inside WAN port is fine.

    Edit: OK. Scratch that. NO ping response, but I CAN access what is needed via IP address. Then I can map and should be OK.

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice