VPN Tunnel with WRV54G

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by wineguy, Oct 8, 2006.

  1. wineguy

    wineguy Network Guru Member

    I currently am running a WRV54G at my office, using quickVPN to access remotely with absolutely no problems (thanks Doc). I now am forced to replace my router at home, and want to set up a VPN tunnel from home with my 54G. Of course, the easy solution is to get another 54G, but my question is VPN tunnel setup with the WRV200. I'm sure someone is running tunnels between the 200 and 54G. I'm just curious on performance, stability, ease of setup, etc. Is the WRV200 - WRV54G VPN tunnel working, easy (relatively) to set up, and stable, or should I get another WRV54G?

    Thanks in advance for the support and suggestions.

  2. DocLarge

    DocLarge Super Moderator Staff Member Member

    WRV54G to WRV200 Works Fine

    A tunnel between the two works fine. What firmware version are you using? As long as it's 2.37.13, 2.38.x, or 2.39.2, you shouldn't have any problems. Attached is a shot of some "wicked" uptime one of my remote WRV54G's has that I usually run a tunnel to from my WRV54g's.


    Attached Files:

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice