Discussion in 'Other Linksys Equipment' started by muku, Aug 3, 2007.

  1. muku

    muku LI Guru Member

    Hello, I have been using the WAG200G gateway for about six months. I had bought the Annex B version because I had an ISDN line. Yesterday, I changed internet and phone provider and my line also changed to PSTN. So I am wondering if there is any way to make the device work with my new line. I was trying to upgrade its firmware to Annex A but after it reaches 4% it stops and says that the firmware is not correct for the device... I also tried some custom firmware that I found in these forums, but I got the same message. So is this possible to be solved through custom firmware or I should buy an Annex A version?
  2. Slimey

    Slimey Network Guru Member

    PSTN as in DSL?
  3. TazUk

    TazUk Network Guru Member

    Upgrading the firmware wont help, the hardware is different so you will need to buy an Annex A router.
  4. muku

    muku LI Guru Member

    Ok, thanks tazuk. I wasn't sure about that, now it's clear ;)
  5. mstombs

    mstombs Network Guru Member

    I would have expected the firmware to load and run, but maybe not work, there is generally only 1 file different - but would expect the hardware transformers etc to be slightly different
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice