WAG325N is slooooow, WHY!

Discussion in 'Other Linksys Equipment' started by KiAnDe, Oct 25, 2007.

  1. KiAnDe

    KiAnDe Guest

    I have just purchase the WAG325N.
    Unfortunately it does not work properly.

    After I just installed the unit it worked fine, but after I was done with my settings it starts to slow down.
    A simple ICMP ping from my local pc to the router starts to get unstable a ping reply on 32 bytes returned from 1 to 7000ms and up.
    I have also tried to ping other computers in the network, and all the communication that goes through the WAG325N is slow.

    My firmware is V1.00.08, so I can’t find any newer versions, I tried to downgrade from V1.00.08 to V1.00.06, but it would not allow it.

    I have tried to cut down one setting after another, as it seems like it gets more stable and faster as the settings gets closer to factory default. But still if it would work in factory default settings it’s useless for me.

    I have tried searching in different forums and help sites and it looks like this unit has a lot of problems.

    Is there a solution for this problem or was it a total waste of money?
  2. SovryNET

    SovryNET Guest

    Hi KiAnDe,

    I have the same problem !!!

    After this post you have sent a mail to Linksys Technical Support ????
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice