WAG54G disconnection problem

Discussion in 'Other Linksys Equipment' started by scoops78, Nov 12, 2007.

  1. scoops78

    scoops78 Guest


    Can anyone give me some solution?

    I got a WAG54G router and he gives for the cable connected pc all the time connected disconnected. And it isn't poosible to have acces too the internet.

    So i did allready seach for the last firmware and installed it (i think it was 1.01.15)

    Is this the last version or can i find a newer one?
    If yes where ?? and whitch?

    Or are there other solutions?

    I wanne thank you allready for the given information.
  2. K-o-E

    K-o-E Guest

    latest that i found is 1.01.22_000

    www.linksys.com (technical support)
  3. mstombs

    mstombs Network Guru Member

    Switch ports failing is a hardware problem, you may be able to keep going for a bit by select 10Mb/s half-duplex - but check your warranty status - see if you can return to Linksys - lots have been replaced!
    If out of warranty look up capacitor replacement here and on Aus whirlpool forums.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice