WAG54G V1 Ports Failing

Discussion in 'Other Linksys Equipment' started by chontay, Sep 12, 2006.

  1. chontay

    chontay LI Guru Member

    I flashed my WAG54G to the latest firmware WAG54G_AnnexA_ETSI_v1.02.7_03_code. Ever since I have had my port forwards breaking all the time.

    If I make a change on them and save it they all work for about 5 minutes. Then Several stop allowing traffic through. But the rest work.

    I was forwarding: SMTP(25), SPOP(995), POP(110), SSL(443) and RDP on 3 three ports 3389, 3390, 3391. These forwards were shared between two servers.

    I also have a VPN tunnel to my work firewall which remains up and perfect at all times. The keep alive worts and even netbios to enable remote machine browsing using DNS forwarding on both sides for name resolution.

    SPOP and POP stop working. But SMTP continue to work. The RDP's fail too!

    I have now removed the RDP's and it seems to be stable again.

    But I'd really like to keep the custom RDP's published.

    Anyone seen this or know a way round it?

    I have factory defaulted and set up again from scratch after the flash. I have flashed back and forth between versions and they all do it apart from the original firmware. I have also tried restoring from a backed up config but it still persists.

    And help would be great thanks.

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice