WAG54Gv2 upgrade.... its dead

Discussion in 'Other Linksys Equipment' started by chris1210, Jun 4, 2006.

  1. chris1210

    chris1210 Guest

    Was busy updating my UK WAG54Gv2 tonight to the new firmware (.27) and of all the times, we get a power cut. Off it goes, powers up and shows lights, but cannot connect to it at all anymore, assume the firmware is now corrupt.

    I can ping it, but not connect...... is there anyway to salvage it??

  2. ReDFlaG

    ReDFlaG Network Guru Member

    1°) Link your computer to your linksys with an ethernet (crossed ?) cable.
    2°) Try to ping the default IP address :, normaly it will work fine.
    3°) Go to ftp://ftp.linksys.com/international/firmware/ and download the right firmware for you router
    WARNING, it's necessary to download this file in binary mode.
    4°) Find a TFTP server that work with password
    5°) Start this tftp Server, set it up (host name : and
    Select the right firmware file. In the password field, put de default linksys password : admin

    Then press "send" button.
  3. HiSpeed

    HiSpeed Network Guru Member

    Are you talking about the button to send... a RMA ? :rofl:
  4. ReDFlaG

    ReDFlaG Network Guru Member

    Of course ! Is not "send" a synonym of "RMA"? :D
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice