WAG54GX2 - Disconnection issues

Discussion in 'Other Linksys Equipment' started by Adresch, Nov 19, 2006.

  1. Adresch

    Adresch Guest

    Can anyone offer any advice?

    Short version of my problems goes as follows

    We had bulldog installed last year, roughly november time

    All worked Aok, no problems, worked right up until we had the 16mb upgrade done

    Ever since then, the broadband intermittently disconnects and reconnects

    It does this several times a day, sometimes two/three times in the space of 2/3 minutes

    Bulldog did a few line tests, results were

    1) Line is perfect, must be your equipment
    2) There's some resistance on the line, but no line noise

    Replaced the microfilter, with a BT certified one and another one, same problem
    Replaced the DSL cable for a shielded, high quality one, same problem

    Eventually BT came out, did some tests, they saw the resistance to, the engineer said it was because of rubbish shielding/insulation on the cables in the CAB
    That was fixed, same problems exist

    For instance, so far today, it's cut off 4 times in the space of 10 minutes

    The router (Linksys, WAG54GX2) is the only thing connected to the master socket, there is no phone, or extension cable.

    Can anyone suggest anything?

    I've tried the original 1.00.01 firmware, as well as the 1.00.09 one, still the same
  2. devries25

    devries25 LI Guru Member

    In Configuration ... Setup Page ... Basic, what MTU setting is applied? If it is Auto, try setting it to manual and choose 1492. If still getting drop-outs, try lowering the MTU setting bit by bit until you no longer have dropouts.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice